Industries We Serve
Who we supply — across India’s textile value chain
From circular-knit hosiery units to shirting mills, denim weavers, garment exporters and home-textile manufacturers, AA Enterprises supplies yarn and fabric to every link in India’s textile chain — a sector employing over 45 million people directly. We match count, blend and spin to what your machines and your market actually need.
The businesses we supply
Knitters & hosiery
Combed and carded cotton, CVC and bamboo for tees, innerwear and socks. See yarn for t-shirts and socks.
Weavers & shirting mills
Warp and weft yarn for shirting and bottom-weights. See yarn for shirting and weaving yarn.
Garment exporters
Consistent, programme-grade yarn and fabric for export cut-and-sew.
Home-textile makers
Yarn for towels, bedsheets and furnishing. See home textiles and towels.
Dye houses & converters
Greige yarn and fabric ready for your dyeing and finishing.
Trading & wholesale
Reliable supply and a wide range for traders and wholesalers.
Wherever you are in India
Based in Delhi, we dispatch mill-direct to textile hubs across India — Tirupur, Ludhiana, Surat, Ahmedabad, Panipat and beyond. See locations we serve.
What each industry actually buys
Every sector below buys yarn, but they buy different yarn, judge it on different parameters and fail for different reasons. Knowing which one you are dealing with is most of the job.
| Industry | Typical counts | What they judge it on |
|---|---|---|
| Knitwear & hosiery | Combed 24s–40s | Evenness, low twist, shade continuity |
| Woven shirting | Combed 40s–80s | Warp strength, CV%, sizing behaviour |
| Denim | 7s–16s ring and OE | Warp strength, weft bulk, dye uptake |
| Home textiles | 10s–40s, dyed and grey | Cost per kg, shade matching |
| Towels & terry | 10s–30s, split pile/ground | Absorbency in pile, strength in ground |
| Uniform & institutional | PC 65/35, 20s–40s | Shrinkage, wash durability, price |
| Technical & industrial | Polyester and blends | Tensile strength, dimensional stability |
| Handloom & craft | 40s–100s, dyed | Hand feel, dye take-up, small lots |
Knitwear and hosiery
The largest single consumer of combed cotton in India. Circular knitters need yarn that runs without breaks and shows no banding after dyeing, which makes count CV% and lot consistency more important than headline strength.
The two recurring failures are barré from mixed lots and spirality from excess twist. Both are yarn-side problems — see fabric defects.
Woven shirting and suiting
Warp is the hard part. It must survive sizing, beaming and thousands of reed passes, so twist and strength matter more than softness. Weft can be a grade softer and cheaper.
Blended suiting adds a second variable: blend ratio drift shows as visible shade banding after dyeing, which is why PV programmes are usually specified with a ratio tolerance in writing.
Denim
Denim is the clearest case of using two different yarns deliberately. Ring-spun warp at TM 4.2–4.8 for strength through rope dyeing and loom tension; open-end weft for bulk, hand and cost.
Specifying ring-spun for both is a common and expensive mistake — the weft is barely visible in the finished fabric.
Home textiles and towels
Home textiles buy largely on cost per kilogram, often to a price point rather than a fixed count. Recycled and open-end yarn dominate in the Panipat belt.
Towels are the exception that catches people out: pile and ground need different yarns. Soft, low-twist, absorbent for the pile; stronger and higher-twist for the ground. One spec for both means one of them is wrong.
Uniform, institutional and workwear
PC blends dominate because the fabric is washed constantly and must not shrink or crease. Shrinkage tolerance and wash durability are usually contractual, and price is tightly negotiated.
This is the sector where a documented shrinkage figure is worth more than a soft handle.
How we work across sectors
We supply against your specification rather than pushing a house range. Tell us the fabric you are making, the counts and blends you need, and the parameters you judge on, and we will quote from mill.
We can provide mill test reports covering the parameters you specify. We do not hold GOTS or OEKO-TEX certification, so if your programme requires certified material, say so at enquiry stage and we will tell you plainly what we can and cannot cover.
Frequently asked questions
Who does AA Enterprises supply?
We supply knitters, weavers, garment exporters, home-textile manufacturers, dye houses and traders across India.
Do you handle programme and spot orders?
Yes - both ongoing programme quantities and one-off spot orders, with consistent quality.
Do you supply exporters?
Yes - we supply programme-grade yarn and fabric for garment and home-textile exporters.
The value chain we sit in, measured
Who else depends on the same supply base.
India’s textile sector provides direct employment to over 45 million people and is a livelihood for more than 100 million indirectly. It contributes roughly 2% of India’s GDP and about 11% of manufacturing gross value added (IBEF, July 2025).
Cotton alone supports around 6 million farmers and sustains employment for a further 40 to 50 million people in processing and trade. It accounts for close to 19% of global fibre production (PIB, July 2026).
Textile and apparel exports, including handicrafts, stood at ₹3,12,540 crore (US$ 36.61 billion) in FY25 (IBEF, July 2025).
Sources: PIB, White Gold: India’s Cotton Story, 20 July 2026 · TEXPROCIL, Cotton Textiles Export Promotion Council · IBEF, Textiles, July 2025
Every figure above carries the year it refers to and the body that published it. None of them are our own estimates.
Whatever you make, we can supply the yarn
Tell us your fabric, count or blend and quantity, and we will send firm pricing and a delivery timeline.
Request a Quote